Type: 9A3422501001000
Axial design, 90 ° angled.
After drawing no .: ED-0517
Bayonet ring housing stainless steel 1.4301
Housing diameter d1 = 100 mm
Measuring range: -40 ... + 200 ° C
Nominal length L: 285 mm
Max. Installation length L1: 250 mm
Immersion tube diameter: 8 mm
Material: Stainless steel 1.4571
Mech.Anschluss: without
Accuracy: class 1 based on DIN EN 13190.
Axial design, 90 ° angled.
After drawing no .: ED-0517
Bayonet ring housing stainless steel 1.4301
Housing diameter d1 = 100 mm
Measuring range: -40 ... + 200 ° C
Nominal length L: 285 mm
Max. Installation length L1: 250 mm
Immersion tube diameter: 8 mm
Material: Stainless steel 1.4571
Mech.Anschluss: without
Accuracy: class 1 based on DIN EN 13190.
The measuring method
The digital thermometers of the DiTemp product range work with a time-discrete measuring method. The cycle time of the measurement starts from 3 sec, so that the observer can read off a current measured value in passing. The display unit The DiTemp and has an easy-to-read LCD-based display.
The structural design
The instruments of the DiTemp series have a robust mechanical design and are designed for industrial use as well as for use in difficult environmental conditions. The protection class IP65 (front) meets these requirements. Immunity to electromagnetic interference meets the requirements of applicable industry standards.
Continuous self-test
After startup, the instrument performs an internal self-test, which also checks the operability of the connected probe. Automatic diagnostic routines in the microprocessor permanently monitor the sensor signal for plausibility and can thus signal a sensor break via the display unit. The results are displayed as a message.
Possible applications
Beverage industry - Chemical industry - Mechanical and plant engineering - boiler construction - Large gearbox construction - Large compressor construction.
The digital thermometers of the DiTemp product range work with a time-discrete measuring method. The cycle time of the measurement starts from 3 sec, so that the observer can read off a current measured value in passing. The display unit The DiTemp and has an easy-to-read LCD-based display.
The structural design
The instruments of the DiTemp series have a robust mechanical design and are designed for industrial use as well as for use in difficult environmental conditions. The protection class IP65 (front) meets these requirements. Immunity to electromagnetic interference meets the requirements of applicable industry standards.
Continuous self-test
After startup, the instrument performs an internal self-test, which also checks the operability of the connected probe. Automatic diagnostic routines in the microprocessor permanently monitor the sensor signal for plausibility and can thus signal a sensor break via the display unit. The results are displayed as a message.
Possible applications
Beverage industry - Chemical industry - Mechanical and plant engineering - boiler construction - Large gearbox construction - Large compressor construction.
keineDokumente